Part Names And Functions; Front Panel; Rear Panel; Ac Cord - Marantz BD7004 User Manual

ENGLISH
Introduction

Part Names and Functions

Front Panel

7 8
1 2
The unit can also be turned on by pressing the buttons with circled numbers.
1. STANDBY indicator
This indicator lights up in red in standby
mode and turns off when the power is on.
2. POWER ON/STANDBY button
Press to turn on the unit, or to turn the unit
to the standby mode. (In standby mode, this
unit still consumes small amount of power.
To completely shut down the unit, you must
unplug the AC cord.)
3. HDMI RESOLUTION button
Press to set the HDMI jack's video signal
output mode.
4. Infrared sensor window
Receives signals from your remote control so
that you can control the unit from a distance.
5. Display
Refer to "Front Panel Display" on page 9.
6. SD card slot
Insert an SD Memory Card, and play back the
contents in it.
7. H / G (SKIP DOWN/UP) button
Press to skip down/up titles/chapters/tracks/
files.
9 10 11 12
3 4 5 6
8. A (OPEN/CLOSE) button
Press to open or close the disc tray.
9. Disc tray
Place a disc when opening the disc tray.
10. B (PLAY) button
Press to start or resume playback.
11. C (STOP) button
Press to stop playback.
12. F (STILL/PAUSE) button
Press to pause playback.

Rear Panel

1
AC IN
NETWORK
8
1. AC IN Terminal
Use to connect the AC cord to supply the
power.
2. DIGITAL OUT (COAXIAL) jack
Use digital audio coaxial cable to connect to
an AV receiver, Dolby Digital decoder or
other device with a digital audio coaxial
input jack.
3. COMPONENT VIDEO OUT jacks
Use a component video cable to connect to
a display device with component input jacks.
4. VIDEO OUT jack
Use an RCA video cable to connect to a TV
monitor, AV receiver or other device.
5. FLASHER IN / OUT jacks
This Input terminal is equipped for
controlling this unit by the external Infrared
(IR) control device. Connect the IR control
signal from a Keypad, IR repeater, etc. The
Output terminal repeats the IR signal which
was fed into the IR Flasher Input terminal for
another device.
6. 2ch AUDIO OUT jacks
Use an RCA audio cable to connect these
jacks to the 2-channel audio input jacks of
your amplifier with 2- channel input
terminals.
7
ENGLISH
2 3 4 5 6 7
DIGITAL OUT COMPONENT VIDEO OUT VIDEO OUT FLASHER
IN OUT
COAXIAL
FL C SL
STRAIGHT 2ch AUDIO OUT
CABLE R L
HDMI OUT
RS-232C
FR SW SR
7.1ch AUDIO OUT
9 10
7. 7.1ch AUDIO OUT jacks
Use an RCA audio cable to connect these
jacks to the 7.1-channel audio input jacks of
your amplifier with 7.1-channel input
terminals.
8. NETWORK Terminal
Use to connect a telecommunications
equipment with LAN cable.
9. HDMI OUT jack
Use an HDMI cable to connect to a display
with an HDMI input jack.
10. CONTROL CONNECTOR (RS-232C)
This is a terminal for future system extension.
Note
• Do not touch the inner pins of the jacks on
the rear panel. Electrostatic discharge may
cause permanent damage to the unit.
Introduction
SBL
SBR