Connect The Cable To The Indoor Unit - Panasonic CS-HZ9RKE Service Manual

Replace the drain hose
Rear view for left piping installation
Drain cap
•
How to pull the piping and drain hose out, in case
of the embedded piping.
Apply putty or
caulking material
to seal the wall
opening.
PVC tube for
drain hose (VP-20)
PVC tube
for drain
hose
12.2.4

Connect the Cable to the Indoor Unit

1. The inside and outside connection cable can be connected without removing the front grille.
2. Decide on the type of power supply connection to be used, indoor power supply or outdoor power supply.
12.2.4.1 In case of indoor power supply
3. Install the indoor unit on the installing holder that mounted on the wall.
4. Open the front panel and grille door by loosening the screw.
5. Cable connection to the power supply through Isolating Devices (Disconnecting means).

Connect approved type polychloroprene sheathed power supply cord 3 × 1.5mm
IEC 57 or heavier cord to the terminal board, and connect the others end of the cord to Isolating Devices
(Disconnecting means).

Do not use joint power supply cord. Replace the wire if the existing wire (from concealed wiring, or otherwise)
is too short.

In unavoidable case, joining of power supply cord between isolating devices and terminal board of air
conditioner shall be done by using approved socket and plug with earth pin rated 16A. Wiring work to both
socket and plug must follow to national wiring standard.
6. Bind all the power supply cord lead wire with tape and route the power supply cord via the left escapement.
Drain hose
Connection
cable
Piping
PVC tube (VP-65)for piping
and connection cable
PVC tubefor drain hose (VP-30)
Cable
Piping
Indoor unit
100 mm
Piping
Drain hose
•
In case of left piping how to insert
the connection cable and drain hose.
Drain hose
from main unit
(For the right piping, follow the
same procedure)
33
Connection cable
More than 950 mm
Sleeve for piping hole
Drain
hose
Cable
Piping
2 type designation 60245