Indoor Unit; How To Fix Installation Plate - Panasonic CS-HZ9RKE Service Manual

12.2 Indoor Unit

12.2.1

How to Fix Installation Plate

The mounting wall shall be strong and solid enough to prevent it from vibration.
Wall
HZ9***, AZ9***
HZ12***
The center of installation plate should be at more than  at right and left of the wall.
The distance from installation plate edge to ceiling should more than .
From installation plate center to unit's left side is .
From installation plate center to unit's right side is .
○
B : For left side piping, piping connection for liquid should be about  from this line.
: For left side piping, piping connection for gas should be about  from this line.
1 Mount the installation plate on the wall with 5 screws or more (at least 5 screws).
(If mounting the unit on the concrete wall, consider using anchor bolts.)
o
Always mount the installation plate horizontally by aligning the marking-off line with the thread and using
a level gauge.
2 Drill the piping plate hole with ø70 mm hole-core drill.
o
Line according to the left and right side of the installation plate. The meeting point of the extended line is
the center of the hole. Another method is by putting measuring tape at position as shown in the diagram
above. The hole center is obtained by measuring the distance namely 128 mm for left and right hole
respectively.
o
Drill the piping hole at either the right or the left and the hole should be slightly slanting to the outdoor
side.
12.2.2 To Drill a Hole in the Wall and
Install a Sleeve of Piping
1 Insert the piping sleeve to the hole.
2 Fix the bushing to the sleeve.
3 Cut the sleeve until it extrudes about 15 mm
from the wall.
When the wall is hollow, please be sure to use the
sleeve for tube assembly to prevent dangers
caused by mice biting the connection cable.
4 Finish by sealing the sleeve with putty or
caulking compound at the final stage.
More than
1
Indoor unit
2
3
5
6
Measuring
Tape
Model
or
CAUTION
Wall
More
screw
than
2
128 mm
Installation plate
For best strength of
INDOOR unit installation,
it is highly recommended
to locate " " at 5 position
as shown.
  
490 mm 82 mm 435 mm
Sleeve
for tube
assembly
ø70 mm through hole
31
More than
1
4
241.5 mm
1
128 mm
Dimension
 
435 mm 127 mm
Wall
Indoor Outdoor
15 mm
Putty or caulking compound
Wall

88 mm
Approx. 5 - 7 mm
Bushing for tube
assembly