Panasonic KX-TGF350C Operating Instructions Manual page 51

Problem
The unit does not work.
I cannot hear a dial tone.
The base unit beeps.
The unit does not work during a
power failure.
Menu list
Problem
The display is in a language I
cannot read.
I cannot register a handset to a
base unit.
Battery recharge
Problem
The handset beeps and/or
flashes.
I fully charged the batteries, but
– still flashes,
– is displayed, or
– the operating time seems to be
shorter.
Making/answering calls, intercom
Problem
is displayed.
For assistance, visit www.panasonic.ca/english/support
TGF3xxC(en)_1216_ver011.pdf 51
Cause/solution
R Make sure the batteries are installed correctly (page 8).
R Fully charge the batteries (page 9).
R Check the connections (page 8).
R Unplug the base unit's AC adaptor to reset the unit. Reconnect
the adaptor and try again.
R The handset has not been registered to the base unit. Register
the handset (page 36).
R The base unit's AC adaptor or telephone line cord is not
connected. Check the connections.
R Disconnect the base unit from the telephone line and connect
the line to a known working telephone. If the working telephone
operates properly, contact our service personnel to have the
unit repaired. If the working telephone does not operate
properly, contact your phone service provider.
R New messages have been recorded. Listen to the new
messages (page 41).
R You can insert 2 AAA (R03) batteries (not supplied) into the
base unit that will power the unit temporarily in the event of a
power failure (page 9).
R The base unit display is blank if the saving mode is "On"
(page 10).
Cause/solution
R Change the display language (page 12).
R The maximum number of handsets (6) is already registered to
the base unit. Cancel unused handset registrations from the
base unit (page 36).
Cause/solution
R Battery charge is low. Fully charge the batteries (page 9).
R Clean the battery ends (
dry cloth and charge again.
R It is time to replace the batteries (page 8).
Cause/solution
R The handset is too far from the base unit. Move closer.
R The base unit's AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
R The handset is not registered to the base unit. Register it
(page 36).
Useful Information
, ) and the charge contacts with a
2014/12/16 19:11:03
51