Too Many Disks Installed; Too Many Flash Options Installed; Too Many Trays Attached; Input Config Error - Lexmark C925 User Manual

57 Configuration change, some held jobs were not restored
Something has changed in the printer to invalidate the held jobs. Possible changes include:
• The printer firmware has been updated.
• Paper input options needed for the print job were removed.
• The print job was created using data from a device in the USB port and the device is no longer in the USB port.
•
The printer hard disk contains print jobs that were stored while installed in a different printer model.
Touch Continue to clear the message.

58 Too many disks installed

1
Turn the printer off.
2
Unplug the power cord from the wall outlet.
3
Remove the excess disks.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.

58 Too many flash options installed

1
Turn the printer off.
2
Unplug the power cord from the wall outlet.
3
Remove the excess flash memory.
4
Connect the power cord to a properly grounded outlet.
5
Turn the printer back on.

58 Too many trays attached

1
Turn the printer off.
2
Unplug the power cord from the wall outlet.
3
Remove the additional trays.
4
Connect the power cord to a properly grounded outlet.
5
Turn the printer back on.

58 Input config error

1
Turn the printer off.
2
Unplug the power cord from the wall outlet.
3
Check if all tray configurations are correct. Remove unnecessary trays if needed.
Troubleshooting
184