Handle Installation - Windsor MB1500 Operating Instructions Manual

HANDLE INSTALLATION

DECK
ASSEMBLY
The machine is shipped with handle unassembled.
Follow these steps for installation:
1. Remove handle (38293) and deck assembly
(29230) from carton.
2. Attach handle assembly to base using hardware
kit (47331) (attached to handle in a plastic bag)
items 1, 2, and 3.
NOTE: The spacers (items 1) are required for the
correct operation of the handle. The spacers are
positioned completely inside the pivot holes in the
casting, and are held in place by tightening the bolts
and washers (items 2 and 3) against the spacer.
3-2
HANDLE
RECEPTACLE
4
5
MB1500 98804 09/25/02
6
3. Remove bolt, nut and washers (items 4, 5 and
6) from lower block on handle assembly. Attach
links as shown. Tighten bolt and nut securely,
then back off 1/4 to 1/2 turn.
4. Check handle for movement up and down.
5. Plug motor cord into handle cord receptacle.
HANDLE
ASSEMBLY
MOTOR
PLUG
PIVOT
HOLE
1
SEE NOTE
2
3