Table of Contents
Advertisement
Installation
During installation, make sure that the lettering "top right" is
upside down at the bottom left.
Insert the panel at an angle towards the back (fig. A).
1.
Insert the top panel at an angle towards the back into the
2.
brackets. The smooth surface must face outwards. (fig. B).
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Fault table
If a dish does not turn out as well as you had hoped, refer to
the chapter: Tested for you in our cooking studio.It contains
useful tips and information on cooking, baking and roasting.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Fault
Possible cause Troubleshooting/informa-
The oven does
Faulty circuit
not work.
breaker
Power cut.
Oven not hot.
Dust on the
contacts.
The burner
Power cut or
does not ignite.
damp ignition
plugs.
The gas grill
The protecting
does not work.
plate is incor-
rectly inserted.
20
tion
Look in the fuse box and
check that the circuit
breaker is in working order.
Check whether the kitchen
light or other kitchen appli-
ances are working.
Turn the control knobs
clockwise and anti-clock-
wise a few times.
Light the gas burner with a
gas lighter or a match.
Make sure that the protect-
ing plate is correctly
inserted.
Remove the protecting
plate and reinsert it.
Put the cover back in place and press on it.
3.
Attach the oven door.
4.
Do not use the oven again until the panels have been
correctly installed.
Replacing the bulb in the oven ceiling light
If the bulb in the oven light fails, it must be replaced. Heat-
resistant, 25 watt spare bulbs can be obtained from our after-
sales service or a specialist retailer. Only use these bulbs.
:
Risk of electric shock!
Switch off the circuit breaker in the fuse box.
Place a tea towel in the cold oven to prevent damage.
1.
Unscrew the glass cover by turning it anti-clockwise.
2.
Replace the bulb with one of the same type.
3.
Screw the glass cover back in.
4.
Remove the tea towel and switch on the circuit breaker.
5.
Glass cover
You must replace a damaged glass cover. Suitable glass
covers may be obtained from the after-sales service. Please
specify the E number and FD number of your appliance.
Hide quick links:
Advertisement
Table of Contents
