Appliance Preparation; Top Vent - Heat & Glo 6000C-IPI Owner's Manual

9 9

Appliance Preparation

A. Top Vent
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
NOTICE: Once appliance is set up for top or rear venting,
it CANNOT be changed at a later time.
WARNING! Risk of Fire! DO NOT remove the installed
piece of insulation from the fi rebox top on 8000C-IPI mod-
els. Overheating will occur.
NOTICE: Once the seal cap has been removed it CANNOT
be reattached.
Figure 9.1 Cut the seal cap strap across the rectangles
next to the disk. For rear vent, skip this step.
Figure 9.2 Remove the white gasket material covering
the seal cap.
40 Heat & Glo • 6000C-IPI, 8000C-IPI • 2164-900 Rev. AB • 10/15
Figure 9.3 Remove the seal cap.
Figure 9.4 Remove the insulation basket and white insu-
lation from the center vent pipe.
Figure 9.5 Remove the insulation from the outer vent
pipe. For rear venting there is no insulation in the outer
vent pipe.