Electrical Connection - Miele DG 6500 Operating And Installation Instructions

Connection should be made via a
switched socket. This will make it eas‐
ier for service technicians should the
appliance need to be repaired. The
electrical socket must be easily acces‐
sible after installation.

Danger of injury.
Miele cannot be held liable for unau‐
thorised installation, maintenance
and repair work as this can be dan‐
gerous to users.
Miele cannot be held liable for dam‐
age or injury caused by incorrect in‐
stallation, maintenance or repair
work, or by an inadequate or faulty
earthing system (e.g. electric shock).
If the plug is removed from the con‐
nection cable or if the cable is sup‐
plied without a plug, the appliance
must be connected to the electrical
supply by a suitably qualified electri‐
cian.
If the switched socket is not accessi‐
ble after installation, or if the appli‐
ance is to be hard-wired, an addi‐
tional means of disconnection must
be provided for all poles. When
switched off, there must be an all-
pole contact gap of at least 3 mm in
the switch (including switch, fuses
and relays). Connection data is
shown on the data plate. It must
match the mains electrical supply.
After installation ensure that all elec‐
trical components are shielded and
cannot be accessed by users.
Total power rating
See data plate

Electrical connection

Connection
AC 230 V, 50 Hz
The connection data is quoted on the
dataplate. It must match the household
supply.
Residual current device
For extra safety, it is advisable to pro‐
tect the appliance with a suitable resid‐
ual current device (RCD) with a trip
range of 30 mA.
111