Advertisement
Care & Cleaning
Cleaning
surface burners
To avoid possible
burns DO NOT attempt
any of the cleaning
instructions provided
before turning
OFF all of the surface burners and allow
them to cool.
For proper
gas flow it may be necessary
to clean the
burner
ports. Before cleaning
be sure the gas burners are
turned off. First use a clean DAMP cloth to soak up any
spills. Remove any food
from the burner ports using a small
nonabrasive
brush like a toothbrush
and afterwards
wipe up
using a damp cloth. For stubborn
soils located
in the burner
ports, use a small gauge wire or needle to clean.
Any
spill
on or around
the electrode
must be carefully
cleaned.
Take care
not to hit the electrode
with
any
thing
hard
or it could
be damaged.
For fuji access to the surface
burners, follow
the instructions
for raising and lowering
the cooktop.
Removing
and replacing
surface
burners
Any additions,
changes or conversions
required
in order for this appliance
to satisfactorily
meet
the application
needs must be made by an authorized
qualified
Agency.
To remove
gas burners:
1.
Raise the cooktop.
2.
Remove shipping
screws using a Phillips Head
screwdriver.
See Fig. I for screw locations.
3.
Tilt the burner at the end closest to the support
bar until
the Iocator
tab is released (front burners tilt right, rear
burners tilt left). Move the burner toward
the back of
the range. This will separate
it from the gas valve at the
front of the range.
To replace
gas burners:
1.
Slide the burner tube over the gas valve at the front
of the range (front burners fit over the right valve,
rear burners fit over the left valve on each side of the
range).
2.
Tilt burner so that the locating
tab will slide into slot on
the support
bar. Make sure burners are properly
seated
on support bar and are level (See Fig. 1).
3.
Replace shipping
screws.
4.
Lower the cool<top.
rear burners
shipping
locating
tab
locating
tab
burner
support
bar
Fig. 1
gas
valves
Replacing oven light
(some models)
Be sure the range is unplugged
and all parts
are COOL
before replacing
oven light. Wear
a leather-
faced
glove for protection
against
possible broken glass.
To replace
oven
light
bulb:
1.
Turn electrical
power off
at the main source or
unplug the range.
2.
Replace
bulb with a new
40 watt appliance
bulb
(See
Fig. 2).
3.
Turn power back on again
at the main source (or plug
the appliance
back in).
4.
The clock will need to be
reset with the time of day.
To reset, see the Oven
Controls section in this Use
& Care Guide.
Oven
Light
Fig. 2
18
Advertisement
