Download Print this page

Kenmore 790.7040 Series Use & Care Manual page 15

Hide thumbs Also See for 790.7040 Series:

Advertisement

Care & Cleaning
Cleaning
recommendation
table
Surface
type
Control knobs
Painted body parts
Pointed decorative
trim
Aluminum,
plastic or vinyl trim
Recommendation
For general
cleaning,
use hot, soapy water
and a cloth. For more difficult
soils and
built-up
grease, apply
a liquid detergent
directly
onto the soil. Leave on soil for 30-
60 minutes. Rinse with a damp cloth and dry. Do not use abrasive
cleaners on any
of these materials;
they can scratch. To remove control
knobs, turn to OFF position;
grasp firmly and pull straight
off: the shaft. To replace
knobs after cleaning,
line up
the fiat sides of both knob and shaft; then push knob into place.
Control panel
Before cleaning
the control
panel, turn all controls OFF and if needed remove any
Decorative
trim (some models)
knobs from panel. Clean using hot, soapy water
and a dishcloth.
Be sure to squeeze
excess water
from dishcloth
before wiping
control
panel; especially
when wiping
around the controls area. Excess water
in or around
the controls
may cause damage
to the appliance.
When rinsing, use clean water
and a dishcloth
and be sure to
squeeze excess water
from dishcloth
before wiping
the control
panel.
Oven interior
Gentle
scouring
with a soapy non-abrasive
scouring
pad will remove most spots. Rinse
Porcelain enamel
parts & door
with a 1:1 solution of clear water
and ammonia.
If necessary, cover difficult
spots with
liner
an ammonia-soaked
paper towel for 30 to 40 minutes. Rinse with clean water
and
a damp cloth, and then scrub with a soap-filled
non-abrasive
scouring
pad. Rinse
and wipe dry with a clean cloth. Do not allow food spills with a high sugar or acid
content
(mill<, tomatoes,
sauerkraut,
fruit juices or pie filling)
to remain on the surface;
they may cause a dull spot even after cleaning.
The oven interior is porcelain
coated
and safe to clean with oven cleaners following
manufacturer's
instructions. After cleaning,
remove any oven cleaner
or the porcelain
may become
damaged
during future heating.
Do not spray oven cleaner
on any
electrical
controls or switches. Do not spray or allow oven cleaner
to build up on
oven
temperature
sensing
bulb. Do not
spray
cleaner
on
oven
door
trim,
door
gasket,
plastic
drawer
glides,
handles
or
any
exterior
surfaces
of the
range.
Clean
any
soils
from oven frame and door
liner
outside
the oven door
gasket.
Clean
with hot, soapy
water. Rinse using clean water and a cloth. For additional
cleaning
information
see
General cleaning
in the Care & Cleaning
section.
Oven racks
Remove oven racks from oven cavity
before cleaning.
Clean by using a mild, abrasive
cleaner
following
manufacturer's
instructions.
Rinse with clean water, dry and then
replace
in oven.
Oven door
Use soap & water to thoroughly
clean the top, sides and front of the oven door.
Rinse well. You may use a glass cleaner
on the outside glass of the oven door. Do not
immerse the door in water. Do not spray or allow water
or the glass cleaner to enter
the door vents. Do not use oven cleaners,
cleaning
powders
or any harsh abrasive
cleaning
materials
on the outside of the oven door.
Stolnless Steel (some models)
Only use cleaners and polishes that are specifically
manufactured
for cleaning
stainless steel. Always
rub in direction
of metal grain to avoid damaging.
C)o not use
cleoners
with high concentrations
of chlorldes
or chlorine.
Do not use harsh scrub-
bing cleaners.
Polish with a lint-free
cloth. Always
be sure to wipe excess cleaner/
polish off: from the metal surface as bluish stains may occur during
future oven heat-
ing that cannot
be removed.
Clean heavier soils with hot, soapy water
and a dish-
cloth.
Rinse and dry using clean water and a cloth.
Cookfop surface
Do not use spray oven cleaners
on the cooktop.
See Cleaning
the cooktop
and burner
Surface burners
grates instructions provided
in the Care & Cleaning
section.
Burner grates
15

Advertisement

loading

This manual is also suitable for:

7303 series