Table of Contents
Advertisement
Scope
1
This chapter details the removal and/or replacement procedures required for the following assemblies and/or
items. It is not intended to be a strict policy of maintenance but should be used as a guide only.
2
The assemblies covered (refer to Fig 2.0) are as follows:
Section
Assembly
2.1
Backrest Canvas/Pushhandles
2.2
Armrest Assemblies
2.3
Rear Wheel Assemblies
2.4
Brake Assembly
2.5
Castor Wheel Assemblies
2.6
Swing/Detachable Footrest Assemblies
2.7
Seat Canvas and Chassis
3
For the tools required refer to the list of tools detailed in paragraph 12. Any special tooling and/or torque
requirements will be referred to within the relevant text.
4
General engineering practices and safe working practices must be adhered to at all times.
5
For further information on the assemblies contained within this chapter, contact Customer Services,
INVACARE Ltd., (refer to address in chapter 1) quoting the following details:
5.1
Part Number
5.2
Description
5.3
Quantity required
6
For certain orders the following should also be quoted:
6.1
Serial or batch number
6.2
End user
7
For any ordering or spares procurement, contact INVACARE Ltd., (refer to address in Chapter1) quoting the
details in paragraphs 5 and 6.
11/03
Page
2.7
2.11
2.15
2.21
2.23
2.25
2.27
MAINTENANCE
Page 2.3
Advertisement
Table of Contents
