Table of Contents
Advertisement
Scope
1
This chapter details the removal and/or replacement procedures required for the following assemblies
and/or items. It is not intended to be a strict policy of maintenance but should be used as a guide only.
2
The assemblies covered (refer to Figs 2.0.1 and 2.0.2) are as follows:
Section
Assembly
2.1
Backrest canvas assemblies
2.2
Armrest assemblies
2.3
Rear wheels and motor assemblies
2.4
Brake assemblies
2.5
Castor assemblies
2.6
Swing/Detachable footrest assemblies
2.7
Seat canvas and frame assemblies
2.8
Kerb climber
2.9
Batteries
2.10
Controller
3
For the tools required refer to the list of tools detailed in paragraph 13. Any special tooling and/or torque
requirements will be referred to within the relevant text.
4
General engineering practices and safe working practices must be adhered to at all times.
5
For further information on the assemblies contained within this chapter, contact Customer Services,
INVACARE Ltd., (refer to address in chapter 1) quoting the following details:
5.1
Part Number
5.2
Description
5.3
Quantity required
6
For certain orders the following should also be quoted:
6.1
Serial or batch number
6.2
End user
7
For any ordering or spares procurement, contact INVACARE Ltd., (refer to address in Chapter 1) quoting
the details in paragraphs 5 and 6.
Inspection
8
In general, a weekly visual check will meet all the inspection requirements.
9
Ensure that the following are checked:
9.1
Fabric is undamaged and has no signs of sagging.
9.2
The footrest is correctly fitted.
9.3
Both armrests are securely fitted in place.
9.4
Brake mechanism operates freely and when locked, the chair does not move.
9.5
Footplates are undamaged and are correctly fitted.
9.6
Tyres are in good order and the wheels are not damaged.
02/02
MAINTENANCE
Page
2.7
2.11
2.15
2.21
2.23
2.25
2.27
2.29
2.31
2.37
Page 2.3
Advertisement
Table of Contents
