CAUTIONS IN SERVICING
Initializing INTEGRATED NETWORK AV RECEIVER
INTEGRATED NETWORK AV RECEIVER initialization should be performed when the μcom, peripheral parts of μcom,
and Digital P.W.B. were replaced.
1. Turn off the power pressing ON/STANDBY button.
2. Press ON/STANDBY button while simultaneously while pressing PRESET CHANNEL 2 and PRESET CHANNEL 3
buttons.
3. Check that the entire display is flashing at intervals of about 1 second, and then release the 2 buttons.
The microprocessor will be initialized.
Note: • If step 3 fails, start over from step 1.
• All user settings will be lost and the factory setting will be recovered after the set is initialized.
So make sure to note down your setting beforehand for restoring after the initialization.
[AVR-1912E3 model]
ON/STANDBY
[AVR-1912E2/EA/E1C,2112CIE3 model] s
ON/STANDBY
Service Jig
When you repair the printing board, you can use the following JIG (Extension cable kit).
Please order it from Denon Official Service Distributor in your region if necessary.
8U-110084S
:
EXTENSION UNIT KIT
(Refer to 43 page.)
When you update the firmware by DFW, you can use the following JIG (RS232C to internal connector conversion adapter
with 4P FFC cable kit ).
Please order it from Denon Official Service Distributor in your region if necessary.
8U-210100S
:
WRITING KIT
(Refer to 45 page.)
PRESET CHANNEL 3
PRESET CHANNEL 2
PRESET CHANNEL 3
PRESET CHANNEL 2
:
:
1 Set
1 Set
7