Advertisement
BURNER
STYLE #2 (TWIN BURNER)
CONVERSION
INSTRUCTIONS
Fig. 10
E
Two Piece Burner Cap
i
Remove Burner Mounting Screws
_Orifice
Openings
THIS COOKTOP
iS NOT REMOVABLE.
Do not attempt
to remove
this
cooktop.
For all burner locations:
a. Remove burner grates & lift off the two piece burner cap. (Fig. 8)
b. Remove the two burner mounting screws using the appropriate screwdriver or nutdriver and remove burner head (some burners
may be secured with 3/16" hex head screws or square drive screws) (Figs 9).
c.
Remove the factory installed natural gas orifices from the orifice holders using a 7 mm nutdriver (See Fig 10). Save the natural
gas orifices removed from the appliance for possible future conversion back to natural gas.
d. Replace the orifice in each of the orifice holders with the appropriate
LP/Propane gas orifice from the envelope labeled SCREW
MOUNTED BURNER LP KIT.
Note: There are two identical
orifices for the main portion of the burner and a separate smaller orifice for the center/simmer
portion of the burner. Tighten all orifices until snug. Use CAUTION not to overtighten.
e. Replace burners at all locations and tighten each position with original screws. Burners MUST have a Burner Cap installed to
insure proper ignition and gas flame size.
GAS SURFACE BURNER ORIFICE DATA CHART (Burner
Style #2)
SIMMER
TWIN (Main)
TWIN (Main)
BTU Rating / Natural Gas
750
17,000
18,000
Natural Gas Orifice
0.43
1.46
(Qty 2)
1.67
(Qty 2)
L P Gas Orifice
0.22
0.84
(Qty 2)
0.84 (Qty 2)
LP Orifice Marking Color
Orange
Purple
Purple
BTU Rating*/LP
Gas
750
15,000
15,000
*For operation at elevations above 2000 ft., appliance rating shall be reduced at the rate
of 4 percent for each 1000 ft. above sea level.
4. Convert
Oven
Burner
Orifice
for LP/Propane
Gas
(16,000BTU*)
a. Locate the oven burner spud (See Fig. 11).
b. Using a 1/2" wrench, turn down the adjustable spud, which injects gas
into the oven burner, until snug against the LP/Propane metering pin
(approximately
2-1/2 turns).
c.
Turn oven on to check flame appearance.
Flame should be 3-4" with
a minimum yellow flame. If flame is larger, tighten spud slightly and
recheck. Repeat until flame is 3-4" and blue. Do not over tighten.
5. Convert
Waist-High
Broiler
Burner
Orifice
Flame
for LP/
Propane
Gas (13,500
BTU*) ( Some Models
)
a. Open the oven door.
b. Locate the broiler burner spud and turn down until snug against the LP/
Propane metering pin (approximately
1 to 1-1/2 turns). (See Fig. 11).
c.
Turn oven on to check flame appearance.
Flame should be 3-4" with
a minimum yellow flame. If flame is larger, tighten spud slightly and recheck. Repeat until flame is 3-4" and blue. Do not over
tighten.
Note: For operation at elevations above 2000 ft., appliance
rating shall be reduced at the rate of 4 percent for each 1000 ft.
above sea level.
I
Fig. 11
Oven
BurRer
Orifice
Advertisement
