Rear Brake Control; Gear Shift Control; Kickstart Pedal - Husqvarna WR 250 2013 Owner's Manual

REAR BRAKE CONTROL

The rear brake control (1) is placed on the right-hand side of the
motorcycle. On models TE and SMR as stop switch, during the
braking action, causes the rear light to come on.
1
GEAR SHIFT CONTROL
The lever (1) is placed on the left-hand side of the engine. The
operator must release the lever after each gear change to allow
it to return to its central position before another gear change
can be made.
Neutral position (N) is between first (low) and second gears.
First gear is engaged by pushing the lever downwards; all the
other gears are engaged, by pushing the lever upwards.
The position of the gear shift lever on the shaft can be varied by:
loosening screw; pulling lever out; placing lever in new position
on the shaft when the operation is over tighten the screw and
then tightening the screw.
CAUTION*: Do not shift gears without disen-
gaging the clutch and closing the throttle. The
engine could be damaged by "overspeed"
and shock.
WARNING*: Do not downshift when traveling
at a speed that would force the engine to
overrev in the next lower gear, or cause the
rear wheel to lose traction.
N: Neutral
SPECIFICATIONS - OPERATION - MAINTENANCE
KICKSTART PEDAL
The kickstart pedal (1) is situated on the right-hand side of the
motorcycle.
2
EN- 15