Makita HR4500C Instruction Manual page 7

Depress
the
lock button
and
rotate the
change lever so that the pointer points to
the symbol. Then make sure that the bit
is securely held in place by turning it slight-
ly.
Side handle
CAUTION:
Use the side handle only when chipping,
scaling or demolishing. Do not use it when
drilling in concrete, masonry, etc. The tool
cannot be held properly with this side han-
dle when drilling.
The side handle can be swung
360"
on the
vertical and secured at any desired position.
It also secures at eight different positions
back and forth on the horizontal. Just
loosen the clamp nut to swing the side han-
dle to a desired position. Then tighten the
clamp nut securely.
Pointer
- ,
Change lever
Tighten
Side
grip
CAUTION:
Always use the side grip to ensure operating safety when drilling in concrete, masonry,
etc.
The side grip swings around to either side,
allowing easy handling of the tool in any
position. Loosen the side grip by turning it
counterclockwise, swing it to the desired
position and then tighten it by turning clock-
wise.
7