Schwinn 520 Assembly Manual / Owner's Manual page 28

Condition/Problem Thingsto Check Solution
Nodisplay/partial display/ Batteries Makesurebatteries a reinstalled correctly. If batteries a recor-
unitwill notturnon rectly installed, r eplace witha setofnewbatteries.
Check datacableintegrity Allwiresincable shouldbeintact.If anyarevisibly crimped or
cut,replace cable.
Check datacable Besurecableis connected s ecurely andoriented properly.
connections/orientation Small l atchonconnector should lineupandsnapintoplace.
Check console display for Check forvisual s ignthatconsole display is cracked orother-
damage wisedamaged. Replace Console ifdamaged.
Console Display If Console onlyhaspartial d isplay andallconnections a refine,
replace theConsole.
If theabove steps donotresolve the problem, contact C us-
tomerCareforfurther assistance.
Unitoperates butContact HRcableconnection a t Besurecables areconnected s ecurely.
HRnotdisplayed Console Support Armand
Handlebar
Sensor g rip Besurehands arecentered o n HRsensors. H ands mustbe
keptstillwithrelatively e qualpressure a pplied toeachside.
Dryor calloused h ands Sensors m ayhavedifficulty w ithdried outor calloused h ands.
Aconductive e lectrode creamsuchas "Signa Creme" o r "Buh-
Bump" c anhelpmake betterconduct. Theseareavailable on
thewebor atmedical or somelarger fitness stores.
Handlebar andConsole If testsreveal n ootherissues, H andlebar andConsole Support
Support Arm Armshould bereplaced.
Console displays "Lbat" Batteries Replace batteries
errorcode
Speed displayed i s not Display settowrong unit Console displays units.
accurate of measure (English/Met-
ric)
Console displays "E2"er- Check datacableintegrity Allwiresincableshould beintact.If anyarecutor crimped,
rotcode replace cable.
Check datacable Besurecableis connected s ecurely andoriented properly.
connections/orientation Small l atchonconnector should lineupandsnapintoplace.
Console Electronics If testsreveal n ootherissues, C onsole should bereplaced.
Nospeed/RPM reading Check datacableintegrity Allwiresincableshould beintact.If anyarecutor crimped,
whilepedaling, Console replace cable.
displays "Please Stride"
errorcode
Check datacable Besurecableis connected s ecurely andoriented properly.
connections/orientation Small l atchonconnector should lineupandsnapintoplace.
Check magnet p osition Magnet s hould beinplaceonpulley.
(requires s hroud removal)
Check Speed Sensor ( re- Speed sensor s hould bealigned withmagnet a ndconnected t o
quires shroud removal) datacable. R ealign sensor i f necessary. Replace if thereis any
damage tothesensor o rtheconnecting w ire.