Schwinn 520 Assembly Manual / Owner's Manual page 29

Condition/Problem Thingsto Check
Solution
Console shuts off (enters Check data cable integrity All wires in the cable should be intact. If any are cut or crimped,
sleep mode) while in use replace cable.
Check data cable Be sure cable is connected securely and oriented properly.
connections/orientation Small latch on connector should line up and snap into place.
Reset machine Remove batteries from unit for 3 minutes. Reinstall batteries
and start Console.
Check the position of Speed Sensor Magnet should be in place on pulley.
Speed Sensor Magnet
(requires shroud removal)
Check Speed Sensor Contact Customer Care for further assistance.
Unit rocks/does not sit Check leveler adjustment Adjust levelers until machine is level.
level
Check surface under unit Adjustment may not be able to compensate for extremely un-
even surfaces. Move machine to level area.
Foot pedals loose/unit dif- Hardware Tightly secure all hardware on the Pedal Legs.
ficult to operate
Clicking sound when Check pedal leg to crank Remove pedal legs and reattach.
operating arm connection