Optical Drive - HP ProLiant DL320e Gen8 v2 Maintenance And Service Manual

To replace the component, reverse the removal procedure.

Optical drive

CAUTION:
all bays are populated with either a component or a blank.
To remove the component:
Power down the server (on page 28).
1.
Remove the power from the server:
2.
Disconnect the power cord from the power source.
a.
Disconnect the power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 29).
o
Remove the server from the rack (on page 30).
o
Remove the access panel
4.
Disconnect the optical drive cable from the drive.
5.
Remove the optical drive:
6.
To prevent improper cooling and thermal damage, do not operate the server unless
("Access panel" on page 35).
Removal and replacement procedures 37