Changing The Light Bulb; Changing The Needle Plate - Pfaff 2144 Instruction Manual

2. Machine Assistant 2-13

Changing the light bulb

Switch off the main switch and allow light bulb to cool.
Removing the light bulb:
The light bulb is located inside the needle head of the sewing
machine. Light bulbs can be purchased from your PFAFF dea-
ler (the maximum wattage of the light bulb is 5 watts).
Push the light bulb remover (A) upward as far as it will go. Then
push upwards and turn it half a rotation counterclockwise.
Remove the light bulb.
Replacing the light bulb:
Insert the light bulb into the bulb remover. Guide the light bulb
into the slot of the holder. Push the light bulb upward into the
holder as far as it will go and turn it half a rotation in a clockwi-
se direction. Take out the bulb remover from the light bulb.

Changing the needle plate

Switch off the main switch
Removing the needle plate
Raise the presser foot and push the detachable work support
to the left. Position the needle plate changer (bulb remover) as
shown in the figure and press the needle plate upward first on
the right, then on the left. The needle plate can now be easily
removed.
Replacing the needle plate
Place the needle plate against the rear edge of the cut-out,
then press downwards at the front until you hear it snap in
place. Before you start sewing, check that the needle plate is
lying flat.
Tip: Changing the needle plate is even easier with the feed
dog lowered!