Setting The Gain - Clarion XC2510 Owner's Manual

Single amplifier combination system
In this application, the XC2510 is used to drive a full system.
Gray

Setting the gain

After completing the installation, follow these steps to set the
gain control and perform the final system checks.
1. Turn the gain control all the way counterclockwise.
2. Turn the ignition switch on.
Bridged Mode
In this application, the XC2510 can be wired
for Bridge Mode.
Bridged #1
\\
White
Gray/Black
\\
Bridged #2
\\
Green
Purple/Black
\\
14
Black Purple
(+)
Each bridged channel of the XC2510 Amplifier can
drive one (1) full-range 4-ohm speaker.
-
( )
Bridged Power Output
(+)
Refer to the Specifications in Section 8 (Pg.17) of the
-
( )
manual for additional information on Bridge Mode.
Subwoofer
White/Black
CH1
FR Left
White
Gray/Black
CH2
FR Right
Gray
Green/Black
CH3
RR Left
Green
Purple/Black
CH4
RR Right
Purple
Subwoofer
XC2510/XC2410/XC2110