Vision Fitness U70 Service Manual page 38

CHAPTeR 7: PART RePlACeMeNT gUiDe
7.10 DRiVe belT RePlACeMeNT - CoNTiNUeD
5) loosen the 11mm eye hook nut on each side holding the generator from sliding in the frame (Figure e).
6) Slide the generator towards the rear of the unit (Figure F).
figURe e
figURe f
7) when the generator is slid towards the back of the frame, the tension on the generator belt is reduced so that the belt can be removed from
around the pulley portion of the secondary pulley assembly (Figure G).
8) once the generator belt is removed from around the pulley, the secondary pulley assembly can be slid towards the rear of the unit so that
the drive belt can be removed (Figure h).
figURe g figURe H
9) reverse Steps 1-8 to install a new drive belt.
10) test the bike for function as outlined in Section 7.14.
34