Note : Follow the disassembly procedure in the numerical order given.
2-1. FRONT PANEL
• When removing the front panel assembly on electric power failure,
first open the loading block by turning cam with a screwdriver as
shown in the figure, next pull out the loading block with hand, and
remove the loading panel as shown in the figure, then remove the
front panel assembly.
3 Remove loading panel in the arrow direction.
2-2. BASE UNIT BLOCK
1 Turn the cam to direction of arrow (Counter clockwise) by
minus screw driver.
2 Take off the disc table.
3 Remove the yoke bracket.
4 Remove the MD (BU-5BD20) to the direction of arrow.
SECTION 2
DISASSEMBLY
1 cam
2 disc table
– 6 –
1 Turn in the direction
of the arrow.
2 Pull out disc table.
4 BU-5BD20
bottom of chassis
3 yoke bracket