Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend the server from the rack (on page 27).
3.
Remove the access panel (on page 28).
4.
Remove the processor memory drawer shipping screws, if installed. Retain the screws for future use
5.
("Processor memory drawer shipping screw
Extend the processor memory drawer approximately 2.54-5.1 cm (1-2 inches).
6.
Loosen the thumbscrews on the SPI board, and then lift the SPI board to access the cables.
7.
Disconnect all cables from the SPI board.
8.
IMPORTANT:
number through the Advanced System ROM options in UEFI System Utilities.
Remove the SPI board from the server.
9.
If replacing the SPI board or clearing NVRAM, you must re-enter the server serial
locations" on page 33).
Operations 30