Fujitsu PRIMERGY RX200 S6 Operating Manual page 73

– Power button override
The system can be switched off (hard power off) by holding down the On/Off
button (approximately 4 - 5 seconds).
V
CAUTION!
There is a risk that data may be lost.
– iRMC S2
iRMC S2 offers various options for switching the server on and off, e.g. via
the Power On Off page of the iRMC S2 Web interface.
V
CAUTION when turning the power off
(Windows Server 2008 or Windows Server 2003)!
The operation of the power switch can be specified as "Do Nothing", "Ask
me what to do" (only for Windows Server 2003), "Stand by", "Hibernate",
and "Shutdown" depending on the OS settings. The default is
"Shutdown".
On this server, functions corresponding to "Stand by" and "Hibernate"
are supported as BIOS and hardware functions. However, some drivers
and software installed in the server do not support these functions. For
this reason, functions corresponding to "Stand by" and "Hibernate" are
unavailable on this server. When the operating mode is set to "Stand by"
or "Hibernate", the system may operate improperly or hard disk data may
be corrupted.
For details about operating mode settings, refer to the manual supplied
with the OS.
RX200 S6
Operating Manual
Starting up and operation
73