Fujitsu PRIMERGY RX200 S6 Operating Manual page 72

Starting up and operation
– System already installed:
Ê Press the On/Off button (item 5 in
Power-on indicator (item 6 in
The server is switched on, performs a system test and boots the
operating system.
Switching the server off
Power-on indicator (item 10 in
Ê Shut down the operating system properly.
The server is switched off automatically and goes into standby mode. The
power-on indicator lights up orange.
I
If the operating system does not switch the server off automatically, press
the On/Off button for at least four seconds and/or send a corresponding
control signal for power button override.
Other On/Off options
Besides the On/Off button, the server can be switched ON and OFF in the
following ways:
– Timer-controlled switch-on/off
Using the ServerView Operations Manager or iRMC S2, you can configure
that the server is switched on/off controlled by timer.
– Ring indicator
The server is switched on by an internal or external modem.
– Wake up On LAN (WOL)
The server is switched on by a command via the LAN (Magic Packet
– After power failure
The server automatically reboots following a power failure (depending on the
settings in the BIOS or in iRMC S2).
72
figure 12 on page
figure 12 on page
figure 12 on page
Operating Manual
61).
61) lights green.
61) lights green.
TM
).
RX200 S6