Universal Remote System; Operation - Buick 2012 Regal Owner's Manual

you live, replace Step 2 under
Programming the Universal Remote
System with the following:
Continue to press and hold the
Universal Remote system button
while you press and release
every two seconds (cycle) the
hand-held transmitter button until
the frequency signal has been
successfully accepted by the

Universal Remote system.

The Universal Remote system
indicator light will flash slowly at
first and then rapidly. Proceed with
Step 3 under Programming the
Universal Remote System to
complete.
Universal Remote System

Operation

Using the Universal Remote
System
Press and hold the appropriate
Universal Remote system button
for at least half of a second.
The indicator light will come on
while the signal is being transmitted.
Erasing Universal Remote
System Buttons
All programmed buttons should be
erased when the vehicle is sold or
the lease ends.
To erase all programmed buttons
on the Universal Remote system
device:
1. Press and hold down the
two outside buttons until the
indicator light begins to flash.
This should take about
10 seconds.
2. Release both buttons.
Instruments and Controls
Reprogramming a Single
Universal Remote System
Button
To reprogram any of the three
Universal Remote system buttons:
1. Press and hold the desired
Universal Remote system
button. Do not release the
button.
2. The indicator light will begin to
flash after 20 seconds. Without
releasing the button, proceed
with Step 1 of the section
Programming the Universal
Remote System.
If you have questions or need help
programming the Universal Remote
system, call 1 800 355 3515 or go
to www.homelink.com. You may
also call the customer assistance
phone number under Customer
Assistance Offices on page 13 4.
5-43