Related Manuals for Chamberlain Min i-key 500 SN7000255
Summary of Contents for Chamberlain Min i-key 500 SN7000255
-
Page 1: Programming Guide
Mini-Key 500 PROGRAMMING GUIDE Model: SN7000255 LiftMaster 845 Larch Avenue Elmhurst, Illinois 60126-1196 LiftMaster.com... -
Page 2: Table Of Contents
Introduction — — — Table of Contents Setting the Relay Activation Time Introduction ............. 2 Setting the Maximum Number of Keypad About the Manual Error! Bookmark not defined. Errors (Strikes and Out) About the Mini-Key System Entry Codes ............ 6 Key Terms About Entry Codes Programming Overview ......... -
Page 3: Programming Overview
Programming Overview — — — Programming Overview Important: The Mini-Key comes preprogrammed with factory settings. When the system is first installed, you do not need to program each feature. Review the system’s factory settings before programming (see page 8). You may want different settings than those already defined. Programming Basics All programming occurs with the system's main keypad including sites that utilize the remote (second) keypad. -
Page 4: Entering Programming Mode
Programming Overview — — — Entering Programming Mode The first step in programming the system is to enter programming mode. Once you are in programming mode, the system will remain in this mode until you tell it to exit to the “run” mode, or until 60 seconds pass without an entry on the keypad. -
Page 5: Initial System Setup
Initial System Setup — — — Initial System Setup Setting the Entry Code Length If you decide to change the entry code length after the initial programming, you will need to delete all of the entry codes before changing the code length. Once you change the entry code length, the old codes will no longer be valid and cannot be deleted. -
Page 6: About Entry Codes
Entry Codes — — — Entry Codes About Entry Codes Entry codes are programmable, numeric codes (4-5 digits in length) that allow entry or exit through a gate/door. Tenants enter their assigned code onto the Mini-Key’s keypad to prompt the system to grant access. Mini-Key Unit Entry to Building/Complex... -
Page 7: Deleting An Entry Code
Entry Codes — — — Notes: Relay Codes: — 1 = Cycle Relay 1 Cycle Relay: When someone enters a valid entry code, the relay will energize for a set period of time (see page 5), then de-energize 2 = Cycle Relay 2 (deactivate to re-lock the door). -
Page 8: Programming Quick Reference
Programming Quick Reference — — — Programming Quick Reference FACTORY STEP DESCRIPTION PROCEDURE PAGE SETTING Entering Programming Mode ### + 6-digit Password Exiting Programming Mode 00 + # Set the Relay Activation Relay 1: 1 + Number of Seconds (2-255) + # 1 or 2 (Door Open) Time Seconds...