How To Set Up The Radar - Furuno TZTL12F Installation Manual

Multi function display
Hide thumbs Also See for TZTL12F:
Table of Contents

Advertisement

3.4

How to Set Up the Radar

1. Tap the [Home] icon to show the home screen and display mode settings.
2. Tap [Radar] from the [Settings] menu.
3. Tap [Radar Source], then select the appropriate radar sensor.
Note: If a DRS sensor is connected but does not appear in the [Radar Source] list,
close the list and open it again. The name of the DRS sensor should appear with
a check mark, as in the example below.
4. Drag the [Radar] menu display the menu item [Radar Initial Setup], then tap
[Radar Initial Setup].
5. Referring to the tables below, set up the radar.
[Radar] menu - [Radar Initial Setup]
Menu item
[Antenna Rotation]
[Antenna Heading Align]
[Main Bang Suppression]
[Enable Sector Blanking]
[Enable Sector 2 Blanking]
[Radar] menu - [Antenna Position]
Menu item
[Longitudinal (from bow)]
[Lateral (-Port)]
Menu item
[Antenna Height]
[Auto Tuning]
[Tuning Source]
[Manual Tuning]
[Radar Monitoring]
Description
Select the speed of antenna rotation.
See "How to align the antenna
heading" on page 3-10.
If main bang appears at the screen
center, slide the circle icon so that the
main bang disappears, while watching
the radar echo at the
left-hand side of the display.
Up to two sectors may be selected for
blanking (no transmission). Select
[ON] to enable this feature. Set the
start and end angles (0° to 359°).
Description
Referring to the figure on
the right, enter the radar
antenna positioning
bow-stern (Longitudinal)
and port-starboard
(Lateral) position from the
origin.
Description
Select the height of the antenna
above the waterline.
Enable/disable auto tuning for the
connected radar.
Select the range to tune.
Manually tune the radar.
Not available when [Auto Tuning]
is enabled.
Display various information regarding the connected radar.
3. HOW TO SET UP THE EQUIPMENT
Options (setting range)
[Auto], [24 RPM]
[-179.9°] to [+180.0°]
[0] to [100]
[ON], [OFF]
Options (setting range)
[0] m to [999] m
[-99] m to [+99] m
Origin
Origin
Options (setting range)
[Under 3m], [3m-10m],
[Over 10m]
[ON], [OFF]
[Range1], [Range2]
[-50] to [50]
3-9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tztl15l

Table of Contents