Initial Setup - Furuno TZTL12F Installation Manual

3.3

Initial Setup

This section shows you how to set your system according to the sensors you have
connected.
Note: Some units are set to metric in this section, actual setting ranges vary
depending on the unit of measurement set in the [Units] menu.
1. Tap the [Home] icon to show the home screen and display mode settings.
2. Tap [Settings] to show the [Settings] menu.
3. Drag the main menu, then tap [Initial Setup] to show the [Initial Setup] menu.
4. Referring to the tables on the following pages, set your equipment.
[Initial Setup] menu - [GPS POSITION]
Menu item
[Longitudinal (from
bow]
[Lateral (-Port)]
Menu item
[Boat Length]
[Size of Static Icon]
[Depth Display]
[Transducer Draft]
[Keel Draft]
[Graphic Instruments
Setup]
[Engine & Tank Setup]
[Initial Setup] menu - [DATA ACQUISITION]
Menu Item
[GP330B WAAS Mode]
[WS200 WAAS Mode]
[Data Source]
[Sensor List]
[NMEA0183 Output]
[NMEA2000 PGN Output]
Description
Referring to the figure on the
right, enter the GPS antenna
positioning bow-stern
(Longitudinal) and
port-starboard (Lateral)
position from the origin.
Description
Set the length of your boat.
Set the size of static (such as own ship)
icons.
Select the start point for depth measure-
ment.
Set the transducer draft.
Set the keel draft.
See "[Initial Setup] menu - [GRAPHIC INSTRUMENTS
SETUP]" on page 3-7.
See "[Initial Setup] menu - [ENGINE & TANK SETUP]" on page 3-8.
Description
Select [ON] to use the WAAS mode for the
corresponding GPS antenna.
Select the source for each data to input to the system. If two or more
sources are connected for a data, select one using the pull-down dialog
box. The FURUNO products are shown at the upper part of the list.
Show the information for sensors connected to your equipment. Also,
you can set "Nickname" for them here.
[Port Configuration] - [Baud Rate]: Select
the output baud rate.
[Port Configuration] - [NMEA-0183 Ver-
sion]: Select the NMEA0183 version for
output.
[Sentences]: Select the sentences to out-
put.
Select [ON] for the PGN's (Parameter Group Number, CAN bus
(NMEA2000) message) to output from the CAN bus port.
3. HOW TO SET UP THE EQUIPMENT
Options (setting range)
0 (m) to 999 (m)
-99 (m) to +99 (m)
Origin Origin
Options (setting range)
0 (m) to 999 (m)
50 to 150
[Under Keel],
[Under Sea Level]
0.0 (m) to 99.9 (m)
0.0 (m) to 99.9 (m
Options (setting range)
[ON], [OFF]
[4,800], [9,600], [38,400]
[1.5], [2.0], [3.0]
[ON], [OFF]
3-5