Furuno TZTL12F Installation Manual page 40

3. HOW TO SET UP THE EQUIPMENT
Menu Item
[Sky View]
[Initial Setup] menu - [INTERNAL GPS SETUP]
Menu Item
[WAAS Mode]
[Initial Setup] menu - [SC-30 SETUP]
This menu is only available with SC-30 connection.
Menu item
[WAAS Mode]
[Heading Offset]
[Pitch Offset]
[Roll Offset]
[Initial Setup] menu - [CALIBRATION]
Menu item
[Heading] Offset heading data.
[Speed Through Calibrate speed data. Enter amount in percentage.
Water]
[Wind Speed] Offset wind speed data. Enter amount in percentage. -50% to +50%
[Wind Angle] Offset wind angle data.
[Sea Surface Offset sea surface temperature data.
Temperature]
[Initial Setup] menu - [DATA DAMPING]
Menu item
[COG & SOG]
[Heading]
[Speed Through Water]
[Wind Speed & Angle]
[Rate of Turn]
[Initial Setup] menu - [FUSION]
Menu item
[Connect to Fusion]
[Fusion Auto Volume]
[Minimum Speed]
[Maximum Speed]
[Volume Increase]
3-6
Description
Show the condition of GPS and GEO (WAAS) satellites. Number, bear-
ing and elevation angle of all GPS and GEO satellites (if applicable) in
view of your GPS receiver appear.
Description
Set to [OFF] when using external GPS.
Description
Select [ON] to use the WAAS mode.
Enter the offset value for heading.
Enter the offset value for pitching.
Enter the offset value for rolling.
Description
Description
Set data damping time. The lower the setting
the faster the response to change.
Description
Connects to your Fusion equipment.
Set to [ON] to allow the NavNet TZtouch2 unit to control the FUSION
volume.
Set the minimum speed threshold. Exceed-
ing this speed activates volume auto control.
Set the maximum speed threshold.
Set the amount of extra volume to output.
Options (setting range)
Options (setting range)
[ON], [OFF]
Options (setting range)
[ON], [OFF]
-180° to +180°
-90° to +90°
-90° to +90°
Options (setting range)
-180.0° to +180.0°
-50% to +50%
-180° to +180°
-10°C to +10 °C
Options (setting range)
0 to 59 (seconds)
Options (setting range)
0.0 (kn) to 19.9 (kn)
0.1 (kn) to 99.0 (kn)
10% to 50%