Parameters
Discovery Protocol) request.
Note: It works only if the value of the parameter "network.cdp.enable" is set to 1
(Enabled). If you change this parameter, the IP phone will reboot to make the
change take effect.
Web User Interface:
Network->Advanced->CDP->Packet Interval (1~3600s)
Phone User Interface:
None
To configure CDP via web user interface:
1.
Click on Network->Advanced.
2.
In the CDP block, select the desired value from the pull-down list of Active.
3.
Enter the desired time interval in the Packet Interval (1~3600s) field.
4.
Click Confirm to accept the change.
A dialog box pops up to prompt that settings will take effect after a reboot.
5.
Click OK to reboot the phone.
VLAN is disabled on IP phones by default. You can configure VLAN for the Internet port
and PC port manually. Before configuring VLAN on the IP phone, you need to obtain the
VLAN ID from your network administrator.
Procedure
VLAN can be configured using the configuration files or locally.
<y0000000000xx>.cfg
Configuration
Configuring Advanced Features
Permitted Values
Configure VLAN for the Internet port
Default
155