Maintenance; Cleaning - Honeywell Marathon Reference Manual

Problem
Solid YELLOW LED
when extended battery
is inserted in the dock.
Marathon docked but
cannot work with
accessory cables
connected to dock.
Marathon docked but
Docked LED does not
light up.

Maintenance

Inspect the rubber feet and replace them if missing, broken or cracked. Check the dock regularly for excessive wear at
pressure points. If the dock is mounted to a stable surface, check surface mounting connections periodically and re-tighten as
necessary.
If the dock becomes cracked or broken at any time, it must be taken out of service and replaced. Contact
Assistance for a replacement dock.
There are no serviceable parts in the desktop dock. Do not attempt to open the unit.

Cleaning

Do not use paper towels or harsh-chemical-based cleaning fluids since they may result in damage to the surfaces and/or
battery charging terminals (pins).
Use a clean soft cloth to wipe any dirt, moisture or grease from the Marathon, extended batteries, charging contacts (pins) and
the dock.
Do not use any liquid to clean the extended battery, Marathon, dock, or charging bays. Spray or dampen the cleaning cloth with
liquids/sprays. If possible, clean only those areas which are soiled.
Lint/particulates can be removed from the connectors, charging terminals and charging/docking bays with clean, filtered
canned air.
2-10
Cause
The extended battery is too hot or too cold to
charge.
Marathon not fully seated in dock.
l
Foreign objects inside docking bay or
l
cable connectors.
Marathon not fully seated in dock.
l
Power supply not connected.
l
Solution
Remove extended battery from the spare
l
battery charging bay and allow it to adjust
to room temperature.
If the battery is left in the dock, it will cool
l
down or warm to a temperature upon which
the dock will begin the charge cycle.
However, depending on the temperature of
the Marathon battery, it may take 2-3 hours
to adjust. The battery can cool down faster
if the battery is not in the battery well.
Reseat the Marathon fully into the docking
l
bay.
Remove the foreign objects and reseat the
l
Marathon into the docking bay.
Check the docking bay is clear of foreign
l
objects and reseat the Marathon fully into
the docking bay
Check that power is applied to the Power
l
Jack at the rear of the Marathon Dock.
Technical