Procedure; Torque Measurement; Step 1 - Mount Vehicle Ram Mount Bracket - Honeywell Marathon Reference Manual

Procedure

Note: As there are many different RAM Mounting Brackets available, the following diagrams are representations, not the
actual image.
Equipment Needed: Phillips No. 1 screwdriver and a Torque wrench capable of measuring to 50 inch pounds (5.64±.56 N/m).
Note: Torquing tool is not supplied by Honeywell. Tools needed to attach the RAM Clamp Mount to the vehicle are not
supplied by Honeywell.

Torque Measurement

You will need a torquing tool capable of torquing to 20 inch pounds (1.10 N/m). Torque all screws and bolts according to the
following table:
For these nuts...
10-32 lock nuts
Step 1 – Mount Vehicle RAM Mount Bracket
1. Determine the position for mounting the RAM ball base. Be sure to position the RAM assembly to allow access to the
ports on the back of the vehicle dock.
2. Attach the RAM ball base to the vehicle mounting surface using four 1/4 bolts (or equivalent) fasteners.
Note: 1/4 bolts not included.
IMPORTANT: Mount to the most rigid surface available.
3-6
Torque to
17 - 20 in/lb (0-95 - 1.10 N/m)