System Resets; Hardware Maintenance; Installing A Memory Card; Installation And/Or Replacement - Honeywell Dolphin 75E User Manual

• If you observe that the Honeywell battery supplied is physically damaged, please send it to Honeywell International Inc.
or an authorized service center for inspection, see
• Battery usage by children should be supervised.
• Avoid dropping the terminal or battery. If the terminal or battery is dropped, especially on a hard surface, and the user
suspects damage, send it to a Honeywell International Inc. or an authorized service center for inspection.
• If you are not sure the battery or charger is working properly, send it to Honeywell International Inc. or an authorized
service center for inspection, see
• Excessive discharge can degrade battery performance. Recharge the battery when your terminal indicates low battery
power.
• Although your battery can be recharged many times, the battery life is limited. Replace it after the battery is unable to
hold an adequate charge.

System Resets

See Resetting the Terminal

Hardware Maintenance

When needed, clean the image engine window and the touch screen with a clean, non-abrasive, lint-free cloth. The terminal can
be cleaned with a damp cloth.
Important: All battery and connector doors must be present, undamaged, and properly closed to maintain the environmental
rating of the terminal.

Installing a Memory Card

You can expand the terminal's memory capacity by installing a microSD or microSDHC card. Honeywell recommends the use of
Single Level Cell (SLC) industrial grade microSD or microSDHC memory cards with Dolphin terminals for maximum
performance and durability. Contact a Honeywell sales representative for additional information on qualified memory card
options.
Note: Format memory card before initial use.

Installation and/or Replacement

To install a memory card:
1. Power Off the terminal.
2. Unlock and remove the battery door.
Battery Door Lock
2 - 14
Customer Support.
on page 1-12.
Customer Support.