Table of Contents
Advertisement
Rear Panel
a ANALOG BALANCED OUT (analog balanced
output) 1/2 connectors (XLR type)
Connect the analog input connector of mixer, amplifier, or
other equipment.
You can use menu operations to set the output level and to
disconnect the XLR connector grounding (pin 1) and the
chassis grounding.
For details, see "Setting Analog Audio Output Level (BAL
OUT LEVEL)" on page 29 and "Ground Lift Function
(GROUND LIFT)" on page 29.
b ANALOG UNBALANCED OUT (analog
unbalanced output) 1/2 connectors (TS phone type)
These connectors output the same audio signals as the
ANALOG BALANCED OUT connectors.
Connect these to the TS PHONE input connectors of guitar
effects units and amplifiers, for example.
You can use menu operations to insert attenuators into the
audio output.
For details, see "Setting the Attenuator for the Analog
Unbalanced Output (UNBAL OUT ATT)" on page 29.
c DIGITAL OUT (digital output) 1/2 connectors
(1: XLR type, 2: BNC-R)
These connectors output a digital audio signal in AES3
format. Connect the digital input connector of mixer,
amplifier, or other equipment.
d LAN (Ethernet) (10/100) connector (RJ-45)
This is a 100Base-TX connector for network connection.
Connect to a Windows PC, in order to use the supplied
Wireless Studio software for communications with the
computer.
For connection to a computer, use a category 5 or superior
LAN cable with a maximum length of 100 m (approx.
14
Parts Identification
1 ANALOG BALANCED OUT 1/2 connectors
2 ANALOG UNBALANCED OUT 1/2 connectors
3 DIGITAL OUT 1/2 connectors
q; WORD SYNC IN/OUT connectors and 75 Ω termination switch
4 LAN (10/100) connector
5 ANTENNA a/b IN connectors
8 ANTENNA a/b OUT connectors
9 REM ANT
330 ft). If the connection requires a total cable length
exceeding 100 m (approx. 330 ft), use a hub between the
computer and the DWR-R02D.
Use the following type of cable when:
Directly connecting the computer and the DWR-R02D:
Cross cable
Using a hub between the computer and the DWR-
R02D: Straight cable
CAUTION
• Do not touch the LAN connector directly with your
hands. The transfer of static electricity may result in
malfunction of the unit.
• For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port. Follow the instructions for this port.
ATTENTION
• Ne touchez pas le connecteur LAN directement avec vos
mains. Le transfert d'électricité statique peut entraîner
un dysfonctionnement de l'appareil.
• Par mesure de sécurité, ne raccordez pas le connecteur
pour le câblage de périphériques pouvant avoir une
tension excessive à ce port. Suivez les instructions pour
ce port.
VORSICHT
• Berühren Sie den LAN-Anschluss nicht direkt mit den
Händen. Durch elektrostatische Entladungen können
Fehlfunktionen des Geräts verursacht werden.
• Aus Sicherheitsgründen nicht mit einem
Peripheriegerät-Anschluss verbinden, der zu starke
Spannung für diese Buchse haben könnte. Folgen Sie
den Anweisungen für diese Buchse.
6 AC IN connector
7 DC IN connector
Advertisement
Table of Contents
