Timer Start; Shut Down Input For Remote Starter; Disabling The Remote Start System - Marksman M7a User Manual

Timer Start

This unit can be programmed to start and run the engine every 2 or 3 hours. The engine will run for
the programmed run time and then shut down. This feature is designed for an extreme cold climate.
The system will auto start the vehicle every 2 or 3 hours to prevent engine from cold hard to start
and freezing over. A MAXIMUM OF SIX CYCLES CAN OCCUR.
Important: Timer start should be used in open areas, never start and run the vehicle in enclosed
spaces as a garage or carport
To Activate the Start Timer:
1. Press the button twice to remote start the vehicle. As soon as the vehicle is running and the
parking lights have turned on or flashing.
2. Immediately depress the
(3) times. The siren or horn chirps (3) times. The vehicle is now programmed to start every 2
or 3 hours.
3. Press the brake pedal to stop the vehicle from running.
Note: Unless the installer of this remote start system has reprogrammed the start timer for a 2 hour
duration, the default programmed start time is set to 3 hours.
Exit the Timer Start:
Timer start can be exited manually as follows:
1. Make sure the remote start system is not operating the engine.
2. Turn the ignition On. The LED and parking lights will flash (4) times. The horn or siren chirps
(4) times.
Or
1. Press the button twice to remote start the vehicle. As soon as the vehicle is running and the
parking lights have turned on or flashing.
2. Immediately depress the
parking lights will flash (4) times. The siren or horn chirps (4) times. The vehicle is no longer
programmed to start automatically.

Shut Down Input for Remote Starter

If any of the following conditions exist while the system is operating, the engine will not start or will
shut down:
1. The hood is open.
2. The brake pedal is pressed.
3. Move the optional remote start enable toggle switch to "Off" position (If Installed).
4. Engine is over-revved (Tachometer Checking Type).
5. The pre-programmed run time 5-10-20-30 minutes has elapsed.
6. Transmitter
7. The vehicle refused to start running after 3 unsuccessful attempts.

Disabling the Remote Start system

This feature allows your security system's remote start unit to be temporarily disabled to prevent
the vehicle from being remote started accidentally. This feature is useful if the vehicle is being
serviced or stolen in an enclosed area. To disable the remote start, move the optional remote start
enable toggle switch to the "Off" position.
button then depress the
button then press and hold the
button is pressed twice.
button. The parking lights will flash
button for 2 seconds. The
7