ASSEMBLING AND ADJUSTMENTS
Safety when assembling and
settings
WARNING! Never make adjustments with the
!
machine running. Turn the ignition key to the
"0" position and remove the ignition cable
from the battery terminal.
•
The machine may only be started in its complete design.
If the machine is started without all the guards fitted there
is a risk of personal injuries.
•
Never allow children or other persons not trained in the
use of the machine to use or service it. Local laws may
regulate the age of the user.
•
Electrical shocks can cause injuries. Do not touch cables
or contacts when the machine is running.
•
The machine is tested and approved only with the
equipment originally provided or recommended by the
manufacturer. Always use genuine parts.
Cutting unit
The machine is equipped with a 2-blade Combi cutting deck.
The Combi-unit, equipped with a BioClip-plug, finely chops
the cuttings to fertiliser. Without the BioClip-plug the unit
works in the same way as a rear ejection unit.
The blades are run by two electric motors which are attached
to the cutting deck.
Fitting the cutting head
WARNING! Observe caution to avoid
!
trapping your hand.
1 Push the cutting deck in and make sure the guide bolts fit
into the grooves on the deck frame, one on each side.
8 –
English
2 Fit the cutting deck's pipe together with the deck frame's
pipe.
3 Press in the lock, grasp the pipes and slide in the cutting
deck.
4 Push the deck until you feel the pipes touch bottom.
5 Connect the cables and fit the cover.
6 Set the cutting deck height control in any of the positions
1-5.