Charging The Battery - Husqvarna Rider Operator's Manual

Charging the battery

When charging, the charger must be placed in a well
ventilated area and under a roof to keep out moisture.
1 Make sure that the power switch is in the 0 position.
2 Connect the battery charger to the voltage and frequency
specified on the charger's type plate. The charger must be
connected to a grounded outlet socket.
3 The charger is plugged into the charging socket at the rear
of the machine under the charging cover. Open the
charging cover.
4 Connect the charger to the battery socket. The plug and
socket fit only one way. Press in the plug and lock it in
place.
5 Activate the charger by pressing the power switch.
6 When the battery charger is connected to the grid, a red
lamp lights up on the battery charger.
POWER
FULL (GREEN)
CHARGING (YELLOW)
BATTERY HANDLING
7 The display on the battery charger indicates how much
8 Return the charger switch to '0' position once the battery
9 The acid level in the battery must be checked after
- A yellow lamp will come on when the battery is charging.
- When the battery is fully charged the light turns green.
POWER
FULL (GREEN)
CHARGING (YELLOW)
CAUTION! If the yellow lamp does not turn green after max
48 hours, please contact your authorized servicing dealer.
the battery is charged.
POWER
FULL (GREEN)
CHARGING (YELLOW)
is fully charged. Pull out the plug. Never jerk the power
supply cable to disconnect it from the wall socket.
charging and topped up with distilled water if necessary.
See the "Checking the battery acid level" section.
– 11
English