General; Cleaning; Warning Light - Husqvarna Rider Operator's Manual

General

WARNING! Before carrying out repair work,
!
cleaning or inspection, the machine must be
in standstill and turned off.
Never make adjustments with the machine
running. Turn the switch to the "0" position
and remove the electric cable from the
battery terminal.
Low season is the most suitable time to perform a service or
overhaul of the machine in order to ensure high function
safety during high season.
When ordering spare parts state your machine's purchase
year, model, type, and serial number.
Always use genuine parts.
An annual check-up by an authorised servicing dealer is a
good way to ensure that your ride-on mower performs at its
best the following season.
• Never wear jewellery, watches or similar when cleaning,
carrying out repair work on or inspecting the machine.
Do not modify safety equipment. Check regularly to be sure it
works properly. The machine must not be driven if protective
plates, protective covers, safety switches or other protective
devices are not fitted or are defective.
• Observe the risk of injury caused by moving or hot parts if
the engine is started with the engine cover open or
protective cowlings removed.
• The blades are sharp and can cause cuts. Wrap the
blades or wear protective gloves when handling them.

Cleaning

Clean the machine directly after use. It is much easier to wash
off grass cuttings before they dry.
IMPORTANT INFORMATION Always park the machine on
an even surface with the machine inactivated before
carrying out any maintenance work.
Oily dirt can be removed using a cold degreasing agent.
Spray on a thin layer.
Rinse at normal water pressure. Do not use a high pressure
washer to clean the machine.
Do not direct the jet towards electrical components or
bearings.
20 –
English
MAINTENANCE AND SERVICE
Hose down the cutting unit with water underneath each time
it is used, avoid using a high pressure washer. It is
recommended that you start the machine and run the cutting
deck for a short period after cleaning, so that any remaining
water is blown off.
Lubricate the machine if necessary after cleaning. Carry out
extra lubrication when the bearings have been exposed to a
degreaser or a water jet.
IMPORTANT! Do not use a high pressure washer to clean
the machine. There is a major risk of water penetrating into
bearings and electrical connections. Corrosion attack can
result, which will lead to running problems. Cleaning
additives generally aggravate the damage.

Warning light

WARNING! Let the machine cool down
!
slightly before carrying out checks and
maintenance on it.
The warning lamp is fitted in the control panel.
If a fault occurs in the machine, the lamp lights up red.
Warning light Cause
The cutting unit
has stopped
working due to
high load.
The cutting unit
is lowered when
attempting to
activate.
Constant red light
Low battery
voltage.
Defective cutting
unit motors.
Defective drive
motor
Action
Deactivate the
machine and wait for
the engine to cool
down slightly before
restarting.
Lift up the cutting unit
by pulling back on
the lever to its locked
position. Try to start
again, see 'Turn on
the machine'.
Check the level of
battery acid and
charge the battery.
Contact an
authorised service
workshop.
Contact an
authorised service
workshop.