Remote Access Setting; Alarm Setting Page; External Alarm Input - Aztech WIPC409HD User Manual

WIPC409HD IP CAMERA USER MANUAL
the Check button to check if the parameters entered are correct. You may then click
the Apply button to apply the settings.
Note: before you set up wireless parameters, ensure that the device is
connected to the Internet. After connecting successfully, reboot the
device for the wireless settings to take effect. Upon rebooting the
device, it will take 30 seconds before the camera will automatically pan
and tilt by itself. Another (2) minutes is needed for the camera to
successfully establish a wireless connection to the router.

7.2.3 Remote Access Setting

1） Manufacturer's DDNS and Third Party Dynamic DNS. Please refer to the content of
the part 6.2.
2） UPNP. UPNP stands for universal plug and play. If you enabled UPNP, once the IP
camera is connected into the LAN, it will communicate with the router of the LAN.
It will request the router to open a port to forward its own port.
Before using UPNP function, please ensure that the router's UPNP has also
been enabled. It is also important that some routers do not support a UPNP
feature. If it does not have the said feature, it is suggested to set a Port
Forwarding Function on your router.
3） WAN IP Test. Click the "Show" button, it will show you another page displaying the
WAN IP address when it is connected to the Internet.

7.3 Alarm Setting Page

7.3.1 External Alarm Input

If the alarm input pins have been connected with an alarm detector, please tick the
"External Alarm", and then you will have enabled external alarm function. If the
external alarm detector is open mode, please tick "Open", vice versa.
21