Connection; Connection Instruction; Visiting The Ip Camera - Aztech WIPC409HD User Manual

WIPC409HD IP CAMERA USER MANUAL

4.1 Connection Instruction

Before visiting the IP Camera, you must first connect it to the Network. Plug it to a
power outlet, and check if the light of the LAN port is normal to make sure all of the
communication links are fluency. The connection method likes as seen above.
1) IP Camera-1 and IP Camera-2 are connected separately to 2 different LANs.
2) And these 2 LANs are already connected to the Internet. In order to get the LANs
connected to the Internet, ensure that the router used in the network has an
active internet connection.
3) PC-3 is connected to the Internet.

4.2 Visiting the IP Camera

To visit the IP Camera, you must first configure some of your IP Camera's IP settings.
1) The PC and IP Camera are in the same LAN. If you want to use this PC to visit the IP
Camera, you need to make sure their IP address is at the same segment.
Otherwise you need to reset the IP Camera's IP address.
For example, if the IP Camera-1's IP address in the image above is 192.168.1.139
(at the segment of 192.168.1.x), while the PC-1's IP address is 192.168.0.175 (at the
segment of 192.168.0.x), you will be not able to visit the IP Camera through PC-1.
You must first change the IP Camera-1's IP address to 192.168.0.139.
2)
The PC and IP Camera are in different LANs, but they are all connected to Internet.
For the IP Camera-1 and PC-2, if you want to visit IP Camera-1 through PC-2, you
must first ensure the following:
a)
Ensure that you can visit IP Camera-1 through PC-1 and then do port
forwarding of the IP Camera on Router-1.
b)
The PC-2's visit application could be sent through router-1 to IP Camera-1.
Normally, PC-2 could only send the information to router-1, if you don't
configure the port forwarding settings of the IP Camera-1 on router-1, then
PC-2 would not be able to visit IP Camera-1.
10