The Pan/Tilt Control; Notice (For Initial Use); Visit Ip Camera From Wan; Port Forwarding - Aztech WIPC409HD User Manual

WIPC409HD IP CAMERA USER MANUAL
recorded video, and (5) open a Recorded video. Please click the button of
"open the recorder file" first, and select the file you want to play.

5.2.7 The Pan/Tilt Control

The Pan/Tilt control area allows you to control the cruise of the Pan/Tilt of your IP
Camera through the directional arrow buttons
(Up/Down/Left/Right/Centre/Stop/Left-right cruise/Up-down cruise).
When the IP Camera turns to some position, you can click the "Set" Button, when you
continue to control the Pan/tilt to turn to other position, you could click the "Call"
button, the Pan/Tilt will go back the pre-position.

5.3 Notice (for Initial Use)

Please change the following settings during initial use:
1) Please refer to the content of part 7.4.1 to change the initial passwords of admin,
user, and guest. Their initial passwords are respectively "admin", "user", "guest".
2) Refer to the content of part 7.5.2 to set the System Time.

6 Visit IP Camera from WAN

6.1 Port Forwarding

Follow the "Visit IP Camera from LAN" steps; make sure PC-1 can visit IP Camera-1.
Before the computers in WAN (PC-2, PC-3) can visit the IP Camera-1, must put the IP
Camera -1 into WAN. You can set Port Forwarding on Router-1 to put IP Camera-1
into WAN.
Open the Router Setting interface on PC-1. The interfaces for different routers are
different, and the Port Forwarding settings are different, please refer to the Router's
Manual on how to set these configurations.
For most routers, "Port Forwarding" option can be found under Setting / Firewall
Interface. Fill in the IP address and Port of IP Camera-1 into the corresponding blank.
15