HP Pavilion Maintenance And Service Manual page 65

3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the bottom cover (see
7. Remove the system board (see
To remove the display assembly:
1. Position the computer on its side, partially open.
2. Remove the two Phillips PM2.5×5.0 screws (1) that secure the display assembly to the computer.
3. Open the display to rotate the hinges upward to an angle (2).
4. Separate the display assembly from the computer (3).
If it is necessary to replace any of the display assembly subcomponents:
1. To remove the display bezel:
a. Remove the two screw covers (1) and the two Phillips PM2.0×3.0 screws (2) that secure the
display assembly to the computer.
b. Flex the inside of the top edge (3), the left and right edges (4), and the bottom edge (5) of the
display bezel until the bezel disengages from the display enclosure.
c. Disengage the double-sided tape located in the middle, bottom of the bezel (under the logo) (6).
Battery on page 29).
Optical drive on page
Bottom cover on page
System board on page
30).
34).
48).
Component replacement procedures 57