Setting For Solving Problems - NEC Express5800 120Li User Manual

User Guide
However, the Microsoft operating system products which support /PAE switch option
are limited.
Refer to the following article in Microsoft Knowledge Base to check the supported
products.
■ Microsoft Knowledge Base - Aritcle ID: 291988
"A description of the 4GB RAM tuning feature and the Physical Address
Extension switch"
Below is the example on how to add /PAE switch to Boot.ini file.
1. Click [Start], point to [Settings], and then click [Control Panel].
2. In [Control Panel], double-click [System].
3. Click the [Advanced] tab, and then click [Settings] under [Setup and
Recovery].
4. Under [System Setup], click [Edit] to open [Boot.ini].
5. Add "/PAE" to [Operating Systems] section in [Boot.ini] file, and then save it.
<Example of Boot.ini file>
[boot loader]
timeout=30
default=multi(0)disk(0)rdisk(0)partition(2)\WINDOWS
[operating systems]
multi(0)disk(0)rdisk(0)partition(2)\WINDOWS="Windows
Standard" /fastdetect
multi(0)disk(0)rdisk(0)partition(2)\WINDOWS="Windows
Standard, PAE" /fastdetect /PAE
C:\CMDCONS\BOOTSECT.DAT="Microsoft Windows Recovery Console" /
cmdcons
This is the end of editing Boot.ini file.
operating system" drop-down list box in [Setup and Recovery]
group box, you can make your system start automatically from
the switch you specified.

Setting for Solving Problems

Setup the following issue in advance so that your computer can recover from any
trouble precisely and as soon as possible when it should occur.
Memory Dump (Debug Information)
This section describes the procedures for collecting memory dump (debug information)
in the server.
Note: If you choose one of the items in the "Default
255
www.nec-computers.com
Server 2003,
Server 2003,