Table of Contents
Advertisement
User Guide
Connected more than two Network adapter and specified different protocol for each
adapter, but all the protocols are specified on either adapter.
- It's a design. Each adapter is specified so that all the installed protocols can be
used. The value that can not be specified during Express Setup will all be speci-
fied by default value.
When more than two Network adapter are specified, the detailed specification of
TCP/IP protocol are all set to use DHCP.
- When more than two Network adapter are specified, the detailed specification
of the protocol may all be set by default value. Re-specify the details from Con-
trol Panel.
Not more than two Network adapter is connected, but the detailed specification of
the protocol are all set by default.(e.g. Specified IP Address on TCP/IP, but DHCP
is specified)
- Are you specifying more than two protocols? In this case, the situation will be
the same as connecting more than two Network adapter, so the detailed specifi-
cation of the protocol are all set by default. Re-specify the details from Control
Panel after starting the OS.
The following error log is included in the event log while operating the system:
<Windows 2000>
Event ID: 16
Source: iANSMiniport
Type: Error
Category: None
Description: Team #0: The last adapter has lost link.
Network connection has been lost.
Event ID: 11
Source: iANSMiniport
Type: Warning
Category: None
Description:Adapter link down: Intel(R) 82546EB Based Dual Port Network
Connect...
Though the above error is included in the event log when specifying the teaming, the
LAN driver can work properly.
Problems with Disk Array Configuration
Refer to the Disk Array Controller User Guide.
Problems with Master Control Menu
The master control menu fails to appear:
203
www.nec-computers.com
Advertisement
Table of Contents
