Specifications - Scotsman HID312 Service Manual

HID312, HID525, HID540
Service Manual

Specifications

The ice maker-dispenser is designed to be installed
indoors, in a controlled environment. Although
it can operate in a wide range of air and water
temperatures, it will provide the best performance if
not subject to extremes.
Air Temperature Limitations
• Maximum: 100 F. or 38
o
• Minimum: 50 F. or 10
o
Water Temperature Limitations
• Maximum: 100 F. or 38
o
• Minimum: 40 F. or 4.4
o
Water Pressure, potable
• Maximum: 80 PSI or 5.5 Bar
• Minimum: 20 PSI or 1.3 Bar
Water Pressure, condenser inlet
• Maximum: 145 PSI or 10 Bar
• Minimum: 20 PSI or 1.3 bar; can be as low as 5
PSI or .3 Bar if clean & supplied with 45
Condenser GPM
• 70 F. water: .25 or .95 LPM
o
• 50 F. water: .15 or .57 LPM
o
Water Conductivity:
• Minimum: 10 microSiemens/cm
RO water may be supplied to the potable water
system, but if it has less than the above conductivity,
the water level sensor will not detect water and the
unit will not make ice.
Deionized water will not work and isn't recommended.
Voltage - 60 Hz
• Maximum: 126 Minimum: 104
Operating the machine outside of any of the above
limitations is considered abuse and any resulting
damage is not covered by warranty and could cause a
complete loss of warranty coverage.
C.
o
C.
o
C.
o
C.
o
F. water)
o
Warranty Information
The warranty statement for this product is provided
separately from this manual. Refer to it for applicable
coverage. In general warranty covers defects
in material or workmanship. It does not cover
maintenance, corrections to installations, or situations
when the machine is operated in circumstances that
exceed the limitations printed above.
Product Information
The product is an ice maker-dispenser. It is designed
to be installed on a countertop or on a specific
machine stand.
• All models require a drain. An internal drain basin
separates the ice storage bin's drain from the drip tray
drain.
• A backflow preventer may be required by local
plumbing codes.
• 60 Hz model has a 7.5 ft. power cord with NEMA
5-15P plug.
• Air cooled models flow air left to right and include
a cleanable air filter.
• 4" or 10 cm legs are optional for counter models.
Thread size 3/8 - 16.
• Special models are required for wall mounting.
• Ice or water vending is triggered by touch free
sensors, no other activation method is available.
• For available options and kits, see sales literature.
Scotsman Ice Systems are designed and
manufactured with the highest regard for safety and
performance.
Scotsman assumes no liability or responsibility of
any kind for products manufactured by Scotsman
that have been altered in any way, including the use
of any part and/or other components not specifically
approved by Scotsman.
Scotsman reserves the right to make design changes
and/or improvements at any time. Specifications and
design are subject to change without notice.
April 2015
Page 3