Start Up - Scotsman HID312 Service Manual

HID312, HID525, HID540
Service Manual

Start Up

1. Remove upper front panel
2. Open the water hand valve, observe that water
enters the water reservoir, fills and then shuts off.
Check for leaks. Repair any leaks before going
any further.
3. Switch electrical supply on. Lights on controller
will flash and then the power light will remain on.
The code display will show O.
4. Push and release the On/Off button. The machine
will start the ice making process. The code display
will show F. Air cooled models will discharge warm
air out the right side, water cooled models will
discharge warm (about 110
condenser drain.
5. In minutes ice will begin to fall into the dispensing
bin. Check ice dispensing by holding a container
in front of the Touch Free ice sensor (just below
the ice delivery spout). Ice should flow from the
spout when a container is present, and stop
dispensing when the container is removed.
6. Check water dispensing by holding a container in
front of the Touch Free water sensor. Water will
flow when a container is present and stop when it
is removed.
7. Push the On/Off button to switch the machine off.
8. Unplug or disconnect electrical power.
9. Remove the top panel and the top of the ice
storage bin. Scoop out any ice in the bin and
sanitize the interior of the ice storage bin by wiping
F.) water out of the
o
ON / OFF
April 2015
Page 12
it with a locally approved sanitizer or a mixture of
1 ounce of household bleach to 2 gallons of water,
allow to air dry.
10. Reconnect electrical power.
11. Push the On/off button to switch the machine on.
12. Replace all covers and panels.
13. Give the owner/user the user manual, instruct
him/her in the operation and maintenance
requirements of the unit. Make sure they know
who to call for service.
14. Fill out the Customer Evaluation and Warranty
Registration form, and mail it in to Scotsman or
register the unit at Scotsman's website (www.
scotsman-ice.com).