Power Cord - Quadra-Fire MTV-E2-CSB Installation Manual

Program Schedule
Pre-set settings are shown below.
You can program 4 time periods each day, with different
settings for weekdays and weekends.
Wake- Set to time and tempera-
ture you want in the morning
until you leave for the day.
Leave- Set the time and tem-
perature you want the heat out-
put reduced to during the day.
Return- Set the time and tem-
perature to what you want the
heat output increased to in the
evening.
Sleep – Set the time and tem-
perature to what you want for
overnight.
To Adjust Program Schedules
1. Press SET CLOCK/DAY/SCHEDULE, then SET
SCHEDULE.
2. Press / to set your weekday wake time (Mon-
Fri), then press NEXT.
3. Press / to set the temperature for this
time period, then press NEXT.
4. Set time and temperature for the next time period
(Leave). Repeat steps 2 and 3 for each weekday
time period.
5. Press NEXT to set weekend time periods (Sat-
Sun), then press DONE to save & exit.
NOTE: You can press CANCEL PERIOD to eliminate
unwanted time periods (except Wake).
Program Schedule Override (temporary)
Press or to immediately adjust the temperature. This
will temporarily override the temperature setting for the
current time period.
The new temperature will be maintained only until the next
programmed time period begins. For example, if you want
to turn up the heat early in the morning, it will automatically
be lowered later, when you leave for the day.
To cancel the temporary setting at any time, press RUN
SCHEDULE.
Program Schedule Override (permanent)
Press HOLD to permanently adjust the temperature. This
will override the temperature settings for all time periods.
The "Hold" feature turns off the program schedule and al-
lows you to adjust the thermostat manually, as needed.
Whatever temperature you set will be maintained 24 hours
a day, until you manually change it, or press RUN SCHED-
ULE to cancel "Hold" and resume the prgrammed sched-
ule.
July 1, 2015
Battery Installation and Replacement
NOTE: 2 AA batteries are included with the thermostat
and must be installed before the appliance can be op-
erated.
Press and pull to remove.
Figure 21.1
Install fresh batteries immediately when the REPLACE
BATTERY warning begins fl ashing. The warning fl ash-
es about two months before the batteries are depleted.
Even if the warning does not appear, you should re-
place batteries once a year.
If batteries are inserted within two minutes, the time and
day will not have to be reset. All other settings are per-
manently stored in memory.
G. Power Cord
1. Prior to installing the power cord, turn the dial contro
"OFF".
2. Make sure the wall receptacle has 120vac output.
NOTE: Using a circuit protector can protect the appli-
ance circuits from power surges.
3. The appliance receptical is located on its lower, back
right hand corner. Install the cord to wall and appliance
reception.
4. Refer to owener's manual for appliance operation.
Shock hazard.
• Do NOT remove grounding prong from plug.
• Plug directly into properly grounded 3 prong
receptacle.
• Route cord away from appliance.
• Do NOT route cord under or in front of appliance.
7080-131H
MT VERNON E2
CAUTION
21